Mitsubishi Electric MELSEC iQ-R Series - Page 180

178
5 SEQUENCE INSTRUCTIONS
5.3 Output Instructions
Setting data
■Description, range, data type
*1 If the program is written in ST language or FBD/LD, the data type will be ANY_INT.
• In safety programs executed by the Safety CPU, only safety devices and safety labels of data types described in the table
can be used.
■Applicable devices
*1 Only T and ST can be used.
*2 T, ST, and C cannot be used.
*3 Only K (decimal constant) can be used.
• In safety programs executed by the Safety CPU, only the following safety devices and constants can be used.
*4 Only SA\T and SA\ST can be used.
*5 SA\T, SA\ST, and SA\C cannot be used.
*6 Only K (decimal constant) can be used.
Operand Description Range Data type Data type (label)
(d) Timer device or timer type label  Bit ANY_BOOL
Coil
Value Value set for the timer 0 to 32767 16-bit unsigned
binary
*1
ANY16
*1
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
(DY)
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LS T,
LC
LZ K, H E $
(d) 
*1
     
Coil
Value 
*2

*3

Operand Bit Word Constant
SA\X, SA\Y, SA\M, SA\SM, SA\B SA\T, SA\ST, SA\C, SA\D, SA\W, SA\SD K, H
(d) 
*4

Coil
Value 
*5

*6