17 - 12
17. CNC CONNECTION
17.4 GOT Side Settings
17.4.4 Ethernet setting
*1 For operating CNC monitor function, set N/W No. to "239".
Item Description Range
Host
The host is displayed. (The host
is indicated with an asterisk (*))
―
N/W No.
Set the network No. of the
connected Ethernet module.
(Default: blank)
Network No. of
CNC
*1
PLC No.
Set the station No. of the
connected Ethernet module.
(Default: blank)
Station No. of CNC
Type
Set the type of the connected
Ethernet module.
(Default: QJ71E71)
AJ71QE71
IP Address
Set the IP address of the
connected Ethernet module.
(Default: blank)
IP address of CNC
Port No.
Set the port No. of the connected
Ethernet module.
(Default: 5001)
5001
Communication
UDP (fixed) UDP (fixed)