19 - 2
19. MULTI-CHANNEL FUNCTION
19.1 What is Multi-channel Function?
19. MULTI-CHANNEL FUNCTION
19.1 What is Multi-channel Function?
Multi-channel Function is a function to monitor up to four FA controllers (PLC CPU, temperature controller, inverter, etc.)
on one GOT by writing multiple communication drivers in the GOT.
(1) Before using the multi-channel function
This manual describes the procedure to use the multi-channel function, based on the following system
configuration example.
19.2.1 Bus connection and serial connection
19.2.2 Ethernet multiple connection
(2) System configuration when the multi-channel function is used
The system configuration between GOT and the controllers is the same as that of when not using the multi-
channel function.
For the system configuration between GOT and the controllers, refer to the following.
Each chapter indicating the system configuration
Channel No.1
Channel No.2
Channel No.3
Channel No.4
Installing multiple
communication drivers
Bus connection
OMRON PLC
connection
Temperature
controller
connection
Servo amplifier
connection
Monitoring the devices
of FA controllers
To Next Page
Loading...
Need help?
General
