Mitsubishi GOT2000 Series Connection Manual

16. ROBOT CONTROLLER CONNECTION
16.5 Device Range that Can Be Set
16 - 7
ROBOT CONTROLLER CONNECTION
16
16.5 Device Range that Can Be Set
For details on the device range that can be used on the
GOT, refer to the following.
2.1 MELSEC-Q/QS, Q17nD/M/NC/DR, CRnD-
700
16.6 Precautions
 When setting IP address
Do not use "0" and "255" at the end of an IP address.
(Numbers of *.*.*.0 and *.*.*.255 are used by the
system)
The GOT may not monitor the controller correctly with
the above numbers.
Consult with the administrator of the network before
setting an IP address to the GOT and controller.
 When connecting to the multiple network
equipment (including GOT) in a segment
By increasing the network load, the transmission speed
between the GOT and PLC may be reduced.
The following actions may improve the communication
performance.
• Using a switching hub
• More high speed by 100BASE-TX (100Mbps)
• Reduction of the monitoring points on GOT

Mitsubishi GOT2000 Series Specifications

General

Brand	Mitsubishi
Model	GOT2000 Series
Category	Control Panel
Language	English