MUTOH ValueJet - CR Return Position Adjustment Menu

ValueJet 1304 Service manual
5-25 AP-74109 Rev 1.1
5.7.1 CR Return Position Adjustment Menu
In this menu, you can adjust the CR return position (near end position of the carriage) on the origin side.
“CR Return: Check” moves the carriage three times..
“CR Return: Input” adjusts the return position of the carriage.
Confirms CR return position
Adjusts CR return position
Press [Setting/value +] or [Setting/value -]
to change the setting value.
(Range: -1.0 - 1.0mm, 0.1mm increment)
[<] key
[<] key
[>] key
[>] key