• Do not place the printer in a location under the following conditions. Doing so may cause
the product to fall, become damaged, or cause injury.
• Unstable surfaces
• Slanted areas
• Locations that are subject to vibration from other product
• Do not stand on the printer or place any heavy objects on it.
Doing so may cause it to fall over, become damaged, or cause injury.
• Do not cover the ventilation hole of the printer with cloth, such as a blanket or table cloth.
Doing so could prevent the printer from ventilating and cause fire.
• Keep the printer away from humid and dusty areas. Failure to do so may result in
electrical shock or fire.
(1) Installation Environment Requirements
Choose a place for printer installation following the requirements of the table below.
Table 3-1 Installation Environment Requirements List
Floor loading capability 2940Pa (300kgf/m
2
) or over
Electrical
specifications
Voltage AC 90 V - 120 V ± 10%
Frequency 50/60Hz ± 1Hz
Capacity 10A or more
Environmental conditions Temperature Humidity
Operation
environment
20º C (68F) to 32ºC (86F) 40% to 60%, with no condensation
Plotting accuracy
warranty range
22ºC (71.6F) to 30ºC (86F) 40% to 60%, with no condensation
Rate of change 2ºC/hour or less 5%/hour or less
To Next Page
Loading...
