ValueJet 1304　Service manual
AP-74109 Rev 1.1 5-70
5.13.3 Pump Endurance Menu
This menu performs endurance running for the pump motor assembly.
You can drive the pump motor assembly according to your desired settings. The available settings are shown
below.
• If the number of endurance running cycles is set to -1, the carriage continuously repeats endurance
running until cancel input is given from the operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If
the number of cycles exceeds the maximum value, the counter is reset to 0.
Table 5-21 Set Items in Pump Motor Assembly Endurance Menu
Set item Contents Set value Remark
Running speed Set the running speed of
pump motor assembly.
Super High / High /
Normal
Number of endurance
running cycles
Set the number of endurance
running cycles
-1 to 10000
To Next Page
Loading...
Need help?
General
