MUTOH ValueJet User Manual

ValueJet 1304 Service manual
AP-74109 Rev 1.1 5-76
5.15.3 Heater
In this menu, you can check whether pre-heater, platen heater, and after-heater works properly or not. The
printer sets the temperature at 50
°C and controls the selected heater process. Press [Cancel] key to stop the
operation.
If the temperature reaches to the set value, the printer keeps the temperature control.
5.15.4 History
You can check the maintenance history of the controller board control device. The history is displayed in H
(hour) / M (min.) / S (sec.).
Total operating time of each heater shows the period from when the printer is used in self-diagnosis mode.
Daily operating time is not counted.
[<] key
[<] key
[>] key
[>] key
[<] key
[>] key
[Enter] key㧔When selecting Pre㧕
[<] key
[<] key
Time of using Pre-heater
Time of using Platen Heater
Time of using After Dryer Heater
[>] key
[>] key
[<] key
[>] key

MUTOH ValueJet Specifications

General

Technology	Piezo Inkjet
Ink Type	Eco-solvent ink
Print Resolution	Up to 1440 dpi
Resolution	Up to 1440 dpi
Ink Colors	CMYK, White
Media Width	64 inches
Interface	USB, Ethernet
Operating Systems	Windows