MUTOH ValueJet User Manual

ValueJet 1304 Service manual
9-25 AP-74109 Rev 1.1
9.2.4 Error Messages During File Transmission
This section describes the error messages displayed when sending backup parameters and firmware using
dedicated online software, as well as their recovery actions.
Table 9-6 Error Messages During File Transmission
No. Message Event/
symptom
Check item Action Reference
1 Transfer failed
Data format
error
Firmware data
format is
inappropriate.
Check if transferred
firmware is an
appropriate file.
After confirming it,
install firmware again.
"7.3.5
Firmware
Installation"
p.7-21
2 Transfer failed
Aborted by the
HOST
Cancel button
on PC has been
pressed.
- Transfer firmware
again.
3 Transfer failed
Data timeout
Communication
time-out
occurred.
Check connection
between printer and PC.
After resolving
problem, transfer
firmware again.
4 Transfer failed
Check-sum
error
File checksum
error.
- 1. Transfer firmware
again.
2. If error message is
still displayed,
check if transferred
firmware is an
appropriate file.
5 Transfer failed
Wrong size
xxxxxxxx
Received
wrong size
data.
Check if program file is
appropriate.
After confirming it,
transfer data again.
6 Transfer failed
Incompatible
F/W
Incompatible
firmware.
Check if program file is
appropriate.
After confirming it,
install firmware again.
"7.3.5
Firmware
Installation"
p.7-21
7 Transfer failed
Flash erase
error
ROM erase
error.
Board may be defective. Replace main board. "4.3.3
Replacing
Main Board
Assembly"
p.4-29
8 Transfer failed
Flash write
error
ROM writing
error.
9 Transfer failed
Flash compare
error
ROM
comparing
error.
10 Transfer failed
Unknown
Flash size
FROM written
in unknown
method is
detected.
Normally not detected.
FROM may be
defective.

MUTOH ValueJet Specifications

General

Technology	Piezo Inkjet
Ink Type	Eco-solvent ink
Print Resolution	Up to 1440 dpi
Resolution	Up to 1440 dpi
Ink Colors	CMYK, White
Media Width	64 inches
Interface	USB, Ethernet
Operating Systems	Windows