MUTOH ValueJet - Parameter Update Menu

ValueJet 1304 Service manual
AP-74109 Rev 1.1 5-56
5.11.2 Parameter Update Menu
This menu updates the adjustment parameters. The parameters that can be updated through this menu are as
follows.
NOTE
The updated parameters will not be stored in the flash memory unless the system power is turned
OFF.
• CR return position
• Head rank
• Voltage offset
• Uni-D / Bi-D Low
• Uni-D / Bi-D High
•Side margin
• Not-filled flag
•Serial number
•Debug Bit
[<] key
[<] key
[>] key
[<] key
[>] key
[<] key
[<] key
[<] key
[>] key
[>] key
[>] key
[<] key
[<] key
[>] key
[>] key
[>] key
Head Voltage Offset Menu
Head Parameter Update Menu
CR Return Position Update Menu
Uni-D/Bi-D Low Update Menu
Uni-D/Bi-D High Update Menu
Side Margin Update Menu
Ink Parameter Update Menu
Serial No.Update Menu
[Enter] key
[Cancel] key
[Enter] key
[Cancel] key
[Enter] key
[Cancel] key
[Enter] key
[Cancel] key
[Enter] key
[Cancel] key
[Enter] key
[Cancel] key
[Enter] key
[Cancel] key
[Enter] key
[Cancel] key
[Enter] key
[Cancel] key
Debug Bit Update Menu