MUTOH ValueJet - Adjustment Pattern ALL; Parameter ALL; Error History

ValueJet 1304 Service manual
AP-74109 Rev 1.1 5-50
5.9.1 Adjustment pattern ALL
Confirms printing and prints adjustment pattern.
5.9.2 Parameter ALL
Prints out the set values of various firmware adjustment parameters.
5.9.3 Error history
Prints serious error history and smart chip log.
[Cancel]
[>]key
If media is not set
If head gap is PG-Low
If head gap is PG-High
If the temperature of the preheater and platen
heater is below 42 C
* Pressing [Cancel] key stops control and start printing
If the temperature of the preheater and platen
heater is below 42 C
* Pressing [Cancel] key stops control and start printing
Media set
Change head gap (to PG-Low)
Change head gap (to PG-High)
Finish warm-up
Finish warm-up
Finish printing
After pressing [Enter]key