MUTOH ValueJet - Replacing Lever Sensor

ValueJet 1304 Service manual
4-55 AP-74109 Rev 1.1
4.5.3 Replacing Lever Sensor
NOTE
Before replacing the lever sensor, remove the following covers.
• R side cover: "4.2.1 Removing R Side Cover" p.4-6
1. Move down the pressure lever forward (downward).
2. Detach the lever sensor cable assembly connector from the lever sensor.
3. Release the hook retaining the lever sensor, then replace the lever sensor.
4. To reassemble the unit, reverse the removal procedure.