ValueJet 1304 Service manual
AP-74109 Rev 1.1 8-2
8.1 Introduction
This chapter provides information about the periodical services, part life, lubrication/bonding, and transport.
Before starting any maintenance work, always perform the following operations.
• Turn the printer. power OFF.
• Remove the power cable from the power outlet.
Not doing so may cause electric shock or damage to the electric circuit.
• Unplug the cables connected to the printer.
Failure to do so could result in damage to the printer.
• Make sure there is sufficient space around the printer when performing maintenance
work.
• When servicing the machinery inside with some covers removed, pay special attention
not to be injured by the driving mechanisms.
• Maintenance must be done by more than two person for the following work.
• When disassembling or reassembling the printer and the optional stand
• When packing the printer for transportation
To Next Page
Loading...
