MUTOH ValueJet - Sending Parameters

ValueJet 1304 Service manual
AP-74109 Rev 1.1 7-28
7.3.6 Sending Parameters
NOTE
Before sending parameters, perform the following work.
• Receiving parameters: "7.3.4 Receiving Parameters" p.7-19
• Firmware installation: "7.3.5 Firmware Installation" p.7-21
NOTE
The extension of parameter file is “*.prm“
.
1. Click [Parameter Send] on the main window.
2. When the “Select of send parameter file”
window opens, select the parameter file to be
transferred and click [Open].
* Click [Cancel] to return to the main window.
3. In the “Parameter Send check” window, click
[OK] to start sending.
* Click [Cancel] to return to the main window.