MUTOH ValueJet - PF Motor Endurance Menu

ValueJet 1304 Service manual
5-69 AP-74109 Rev 1.1
5.13.2 PF Motor Endurance Menu
This menu performs endurance running for the PF motor.
You can drive the PF motor according to your desired settings. The available settings are shown below.
TIP
• The following table shows the motor moving parameters to media feed amount.
• If the number of endurance running cycles is set to -1, the carriage continuously repeats endurance
running until cancel input is given from the operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If the
number of cycles exceeds the maximum value, the counter is reset to 0.
Table 5-20 Set Items in PF Motor Endurance Menu
Set item Contents Set value Remark
Media feed amount Set the media feed amount
per endurance running
cycle
0.1 to 100 Unit: mm
Number of endurance
running cycles
Set the number of
endurance running cycles
-1 to 10000
Speed
35CPS
Acceleration
0.1G
Deceleration
0.1G
Media feed amount
Endurance count
Performing endurance
[Enter] key
[Enter] key
[Enter] or [Cancel] key