MUTOH ValueJet - Page 233

ValueJet 1304 Service manual
5-63 AP-74109 Rev 1.1
(7) Debug Bit update
Updates the debug bit. This is a trial function for firmware.
TIP
• Debug bit is displayed as a binary number. The factory-setting value and default value are as
follows.
• Factory-setting value: 000000
• Default value: 000000
NOTE
This function is not used in maintenance work.
[<]key
[<]key
[<]key
[<]key
[<]key
[<]key
[>]key
[>]key
[>]key
[>]key
[>]key
[>]key
[<]key
[>]key
[Enter]
[Enter]
[Enter]
[Enter]
Input value (digit by digit)
Change the setting value by pressing
[+] or [-]key
If any parameter has been changed