If “waiting for command” is not displayed, follow the steps below.
If IP address that is not default is displayed on the board, releasing [Back] key will display
[IP192.168.xxx.xxx] (depending on the set address) on the LCD. In this case, display either of the
default IP (IP 192.168.1.253) or the set IP address using [+] and [-] key, and press [Enter] key.
Then, “waiting for command” will be displayed.
1. When the printer is in the operation status or in
the menu display status, press [Power] key to
turn the printer off.
2. While holding down [<] key in the operation
panel, press [Power] key.
The LCD displays [Board Manager Mode]. If [<]
key is released, the display turns to “Waiting for
command”.
To Next Page
Loading...
