ValueJet 1304 Service manual
AP-74109 Rev 1.1 7-22
2. Slide DIP SW 2 (SW3) to left (origin side).
3. Turn the printer on with Board Manager Mode.
"(7) Connecting Printer to PC" p.7-17
5. Install firmware referring "(2) Transferring Firmware" p.7-24 and "(3) Confirming Completion of
Installation to Printer" p.7-26.
6. Send parameters referring "7.3.6 Sending Parameters" p.7-28.
No. Item
1MAIN board
2 DIP SW
3DIP SW 1
4 DIP SW 2
4. Select default IP address “192.168.1.253” using
[+] and [-] key on the control panel, and press
[Enter] key
To Next Page
Loading...
