5.2.2 Starting Up 247
5.2 Preparation VJ628XE-M-00
(2-a)Starting Up the Self Diagnosis Mode
• You need a jig panel (operation panel) for self diagnosis function.
• You need to display self diagnosis menu on the operation panel to use self
diagnosis functions.
The self-diagnosis menu is completely independent from the normal operation
mode or setup menu display mode. Switch to the self-diagnosis menu display
mode, following the steps below:
1 While pushing three of the[-]key to Jig panel, [+] key
and [>] the key at the same time; Push [Power] key.
Self diagnosis menu is displayed.
To Next Page