Tunnels for IPv6
540
Managed Switches
b. Above the table heading, Under IP Interface Configuration, click 2.
c. Select the 2/0/1 check box for port 2/0/1.
The settings for port 2/0/1 display in the fields in the table heading.
d. Configure the following settings:
• In the IP Address Configuration Method field, select Manual.
• In the IP Address field, enter 195.1.5.2.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
e. Click Apply.
4. Create an IPv6 routing interface.
a. Select Routing > IPv6 > Advanced > Interface Configuration.
A screen similar to the following displays.
b. Above the table heading, Under IP Interface Configuration, click 2.
c. Select the 2/0/24 check box for port 2/0/24.
The settings for port 2/0/24 display in the fields in the table heading.
d. Configure the following settings:
• In the IPv6 Mode field, select Enable.
• In the Routing Mode field, select Enable.
e. Click Apply.
To Next Page
Loading...
