Oce PlotWave 900 User Manual

DescriptionSetting
'The length of the separation sheet. Only
valid when 'Custom' was selected for
'Roll'. For 'Automatic' roll selection, the
separation sheet will have the width and
length of the previous page.'
Note:
To avoid long plots, the separa-
tion sheet will be no longer than
1230 mm (48.4 in) plus the
length of the additional strip.
'Sheet length when custom roll'
'Add an additional leading strip to the
length of the separation sheet.'
'Add strip'
'When 'Add strip' is 'enabled', add the
given length as leading strip to the separa-
tion sheet.'
'Add strip: strip length'
'When enabled, job information will be
printed on the last separation page. This
only applies to the first time a job is
printed. When the job is reprinted from
the Smart Inbox, the separation sheet is
blank.'
'Print job info on last page'
2. Click “Edit” in the settings group bar or click on the value of a single setting.
3. Click 'OK' to confirm you entries or 'Cancel' to reject your entries.
Chapter 3 - Define your workflow with Océ Express WebTools112
Define the separation sheet preferences

Oce PlotWave 900 Specifications