Oce PlotWave 900 - Specify the Number of Overwrite Passes

Specify the number of overwrite passes
Introduction
The E-shredding function allows you to erase jobs from the system. This prevents unau-
thorized people from accessing the jobs. You can manually enter the required number of
overwrite passes. Therefore, the setting 'E-shredding algorithm' must be set to 'Custom'.
The more passes you define, the more reliable the erasing of jobs is. However, more
passes take more time. You can enter any number from 1 to 35. The factory default is 3.
Before you begin
Make sure that 'Custom' is selected as the e-shredding algorithm.
How to specify the number of overwrite passes
1.
Go to 'Configuration' - 'Connectivity' - 'E-shredding' - 'E-shredding custom number of
passes'.
2.
Click .
3.
Enter the required number of overwrite passes.
Chapter 3 - Define your workflow with Océ Express WebTools 83
Specify the number of overwrite passes