Configure your printing system
Change the regional settings
Note:
Before you can edit a setting or a settings group, you must log on as a key operator or
power user.
If you want to change the initial configuration of the regional settings, you can do so in
the 'Preferences' - 'System settings' - 'Regional settings'.
Define the following settings.
•
'First language' and 'Second language' of the operator panel(s).
You can toggle between these two languages on the operator panel(s).
•
'Measurement unit'
Every time you change the 'Measurement unit', the controller recalculates the values
from millimeter to inches and vice versa.
•
'Media series'
•
'Date format'
•
'Time format'
Current date and time
Make sure that you select the right time zone and the current date and time.
•
'Time zone' - This information is used to correct for daylight saving time.
•
'Current date and time' - This information is used for date and time settings.
Chapter 3 - Define your workflow with Océ Express WebTools84
Change the regional settings
To Next Page
Loading...
