Oce PlotWave 900 User Manual

Deliver originals after scan jobs
Introduction
You can choose for delivery of the original to be at the front (rewind) or the back side of
the scanner.
Attention: The “Rewind” function is disabled when the optional Océ Delivery Tray is
installed.
Note:
When you copy thick or very thin originals, originals that are damaged or originals in
a carrier sheet, it is recommended to use the output at the back side of the scanner to
ensure correct delivery (“Rewind” function off).
Select original delivery
1.
Select the “Preference” section.
2.
Press the ‘Rewind original’ function key to make your selection:
•
On: Originals are delivered at the front of the scanner. You have to collect each original
by hand.
•
Off: Originals are delivered at the back of the scanner.
Chapter 6 - Use the Océ TDS600 scanner to copy 189
Deliver originals after scan jobs

Oce PlotWave 900 Specifications