Oce PlotWave 900 - Cleaning Reinforcement Knives

Clean the reinforcement knives
Introduction
The knives of the reinforcement unit get sticky from the glue on the reinforcement tape.
You must clean the knives regularly. If you clean the reinforcement knives, you must put
the knives in such a position that you have access to all the parts.
You are recommended to clean the knives when:
•
You install a new tape roll. See ‘Insert a new tape roll’ on page 278 or
•
When an error in the reinforcement unit has occurred.
Caution:
Use only the original Cleaner K and Fixing Unit Cleaning Oil (silicon oil) from Océ to
prevent damage to the reinforcement unit.
Clean the reinforcement knives
1.
Press the “Online” key on the printer operator panel to put the printer offline.
2.
Select “Folding” with the left selection key.
3.
Press the down key to enter the “Folding” menu.
4.
Select “Clean knife” with the left or right key.
Note:
When a job is running, the message “Job interrupted” appears. The machine stops running
after it has correctly finished the prints that were already printing. The focus can now be
set to the Folding menu. A picture of the printer appears on the display with the side
door of the reinforcement unit blinking.
5.
Press the down key to put the reinforcement unit knives in the correct position.
6.
Open the side door of the reinforcement unit.
Chapter 11 - System maintenance288
Clean the reinforcement knives