Scanning originals with filing strip
Introduction
Left hand side: You can adjust the original guide of the scanner to remove a filing strip
along the left hand side (in the feed direction, face-up). This side can be reduced by up
to 60 mm.
Copying with removed filing strip along the left-hand side
1.
Press the handle underneath the original guide and move it to the right-hand side.
[139] Adjusting the original guide to add or remove a filing strip along the left-hand side
2.
Make all required settings.
3.
Insert the original face up, left aligned with the original guide on the original feed table.
Right-hand side
You can also remove the filing strip along the right-hand side (in the feed direction, face
up) by selecting a specific roll. If the paper width of the original is larger than the paper
width of the selected roll, the remaining part on the right-hand side will not be scanned.
Chapter 8 - Special copy and scan jobs 215
Scanning originals with filing strip
To Next Page
Loading...
