Select the required media
Introduction
The ‘Media’ setting can be used to select output material and format. The display will
show you what rolls or sheet feeders are currently loaded. The currently selected roll or
manual feed is indicated by the ‘l’ symbol.
If you select ‘Automatic’, the Océ TDS600 scanner will try to use a roll or sheet feeder
format that matches the original size. After inserting the original, the roll or manual feed
that is used is indicated by the ‘m’ symbol.
Note:
The ‘0’ symbol remains in place until a new original is inserted. It may then move to
indicate another roll or sheet feeder, depending on the original format.
First select the paper series, then select the media size.
Note:
The zoom factor is based on the selected media size.
Select the paper series
1.
Select a template.
2.
Select the ‘Sheet’ card in the ‘Original’ section.
3.
Select the required paper series with the ‘Paper series’ function key.
[119] Select the required paper series
Select the required media
1.
Select the ‘Sheet’ card in the ‘Print’ section.
Chapter 6 - Use the Océ TDS600 scanner to copy182
Select the required media
To Next Page
Loading...
