Oce PlotWave 900 - The Copy Size

The copy size
Introduction
The copy width depends on the selected roll and the custom-defined scan width. The
copy length depends on the selected cut option.
Copy non-standard size originals
1.
Open the ‘Sheet’ card of the ‘Print’ section
2.
Use the function key to select ‘Media’
3.
Select ‘Automatic’, or select the roll or sheet feeder with the correct width.
Note:
The media can also be selected directly from the ‘Custom’ section.
4.
Press the ‘Cut length’ function key to select the required cut option:
•
Standard, which cuts copies at a standard length.
•
Synchro, which cuts copies at the end of the image. The system cuts at the measured
length of the original times the zoom factor.
•
Custom (numeric), which cuts copies at a specified length. You can define the copy
length yourself using the arrow keys or the numeric keys.
5.
Make other settings as required.
6.
Feed the original.
Chapter 8 - Special copy and scan jobs228
The copy size