Oce PlotWave 900 User Manual

Use the manual feed for copy jobs
Introduction
If you want to copy a job on a media type or size that is not available on one of the media
rolls, it may be easier to manually feed cut sheets instead of switching media rolls. The
manual feed is a special slot just above the roll drawers on the print engine. You can insert
precut copy material in this slot, one sheet at a time.
Note:
Only use media as specified. For more information, see ‘Preferred Océ media types and
sizes’ on page 374.
Copy on precut sheets
1.
Press the Manual feed key on the scanner operator panel.
2.
Select any required other settings.
3.
Enter the number of copies using the numeric keys.
4.
Feed the original. The printer display indicates e.g. Manual feed A0.
[107] The printer operator panel with the manual feed message
5.
Press the Start key.
6.
Take your sheet of copy material to the side of the printer engine that contains the
Manual feed.
7.
Use both hands to align the copy material in accordance with the format indication and
the sticker on the manual feed table.
8.
Move the copy material forward in the nip of the roller. This must cause an ample paper
bulge over the full width of the page.
9.
Hold the paper with both hands until the engine pulls in the first part of the sheet. The
bulge will be reduced or it will disappear. A few seconds later, the complete sheet will be
pulled in the printer.
Note:
If the copy job requires more sheets, the display will ask you to feed the next sheet.
10.
Repeat steps 7 to 10 to complete the job.
11.
Collect your output.
Chapter 5 - Use the Océ PlotWave 900 scanner to copy 165
Use the manual feed for copy jobs

Oce PlotWave 900 Specifications