Oce PlotWave 900 User Manual

Configure a local scan destination
Note:
Before you can edit a setting or a settings group, you must log on as System administrator
or Power user.
1.
Click 'Configuration' - 'Scan destinations'.
2.
Click 'Edit' in a 'Scan destinations' bar.
3.
Enter a name for the destination.
This name will appear on the scanner operator panel.
4.
Place a check mark in the enabled box.
5.
You can select one local scan destination type:
•
'Local to the Smart Inbox'
When you select this scan destination your scanned files are sent to the 'Scans' Inbox.
This is the fixed scan destination for scan destination 1.
6.
Enter a file name for your scanned files.
The file extension depends on the scanned file type that you select when you start your
scan job on the scanner operator panel.
If you enter a generic name, for example: scan###.*, the scanned files automatically get
a unique file name. An ascending number replaces the "###".
7.
Enter a start value for ###. If you enter 001, the first scanned file is named scan001.*.
8.
Click 'Ok' to confirm your entries or 'Cancel' to reject your entries.
Chapter 3 - Define your workflow with Océ Express WebTools88
Configure a local scan destination

Oce PlotWave 900 Specifications