Oce PlotWave 900 - Sections on the Operator Panel

Sections on the operator panel
Introduction
When the job templates are enabled, the scanner operator panel displays the templates.
You need to select a template before the sections will display.
[114] The job templates at the bottom of the scanner operator panel
When you select a job template, the scanner operator panel displays the following sections
with an active ‘Custom’ section.
•
The 'Custom' section, which provides direct access to frequently used settings as defined
by the customer.
•
The ‘Original’ section, which provides access to the settings of the scanner input, the
original.
•
The ‘Print’ section, which provides access to the settings of the printer output, the
print.
•
The ‘File’ section which provides access to the settings of the scan-to-file output.
Custom section
The ‘Custom’ section contains the frequently used settings:
•
Media
•
Media (continued)
•
Input mode
•
Zoom
•
File mode
The key operator defines the content of the Océ Express WebTools. The key operator
can change the content, dependent on the configuration, for example into the following
settings.
•
Media
•
Media (continued)
•
Folding
Chapter 6 - Use the Océ TDS600 scanner to copy 177
Sections on the operator panel