Oce PlotWave 900 - Empty the Waste Box

Empty the waste box
Introduction
If a reinforcement unit is installed, the protective sheet from the reinforcement tape is
stored in a waste box. For each roll of tape, you must empty the box twice.
Note:
You can empty the waste box while the printer is running.
Empty the waste box
1.
Open the waste box.
First pull the waste box to the left-hand side.
•
•
Next pull the waste box to the front'.
[206] Opening the waste box
2.
Empty the box.
3.
Close the waste box.
•
First push the waste box forward.
Chapter 11 - System maintenance286
Empty the waste box