Oce PlotWave 900 User Manual

The belt unit
Introduction
The belt units offer a large capacity and more flexibility. On the belt unit 170 folded A0
prints can be delivered offset stacked. You can adjust the side guides of the belt, depending
on the width of the folded package.
Note:
The belt unit can also be selected from the drivers or the scanner operator panel. The
remote command overrules the key operator setting.
Selecting belt as folded copy delivery on scanner operator panel
1.
Open the ‘Finishing’ card in the ‘Print’ section of the scanner operator panel.
2.
Press the “Folding” function key to select full folding.
3.
Press the “Folded copy delivery” function key to select the belt. You have 3 options (de-
pending on your configuration): the upper belt, the lower belt of both belts.
Chapter 9 - The Folder, Reinforcement unit and Belt unit 251
The belt unit

Oce PlotWave 900 Specifications