Job templates
A job template contains direct access to four settings for fast selection or verification. It
also contains the default settings for a certain job.
[113] The job templates at the bottom of the scanner operator panel
The figure shows an example with the following job templates:
•
Template 1
•
Template 2
•
Template 3
•
Template 4
•
Last used
The key operator defines the settings in the Océ Express WebTools. The key operator
can change the template names, for example into the following template names.
•
Single copy
•
Set copy
•
Manual feed
•
Originals
•
Lasr used
After you select a template, the sections are displayed. The sections provide access to the
settings for the scanner input, the printer output and the scan-to-file output. Use the
Custom Card here to provide access to frequently used settings in relation to the type of
job.
Chapter 6 - Use the Océ TDS600 scanner to copy176
Job templates
To Next Page
Loading...
