Oce PlotWave 900 - Make Copies

Make copies
1.
Place your original face up, left aligned along the original guide. Keep the legend at your
left-hand side.
Note:
When you feed the original, keep it in place until it is transported (about 1 cm (0.4"))
into the machine.
[100] Insert the original
2.
Specify the number of copies using the numeric keys.
3.
Specify the ‘Paper series’ on the ‘Sheet’ card in the ‘Original’ section.
4.
Specify the desired media on the operator panel.
If you select ‘Automatic’, the Océ PlotWave 900 will try to use a roll format that
matches the specified size.
Select a specific roll to use the media you want.
If you select ‘Automatic’, the Océ PlotWave 900 will use a zoom factor that is needed to
obtain a copy without loss of information. After inserting the original, the zoom factor
that is used is indicated by the ‘o’ symbol.
Note:
The zoom factor is based on the selected media size.
5.
Specify the desired brightness on the operator panel. You can use the ‘Brightness’ setting
to correct for a lighter or darker original.
6.
Specify a reduction or enlargement factor on the operator panel by using the ‘Zoom’
function.
Chapter 5 - Use the Océ PlotWave 900 scanner to copy158
Make copies