Oce PlotWave 900 User Manual

Scanner operator panel
Introduction
The scanner operator panel is located above the original feed.
The panel consists of a display in the center surrounded by a number of function, section
and ‘Arrow’ keys. To the left of the display, you can find the Stop and Job interrupt keys
and below the display you can find the Start, Numeric and Correction keys.
This section consists of two parts. The first part explains the basic use of the keys. The
second part deals with special use of the display.
It describes how to use the soft keys above and along the sides of the display to define
your copy settings.
Illustration
1 2 3
4
5
6
7
8
91011
12
13 14
[90] Océ PlotWave 900 Scanner operator panel
Keys on the operator panel
#
DescriptionNameNum-
ber
The display1
Section keys2
Arrow keys3
There are 6 Media selection keys – one for each
roll. Press the Media selection key to select the roll
with the required format and media type.
Media selection keys4
Chapter 5 - Use the Océ PlotWave 900 scanner to copy144
Scanner operator panel

Oce PlotWave 900 Specifications