Change the operator panel language
Introduction
It is possible to change the operator panel language. You can choose between two preferred
languages. Define the first and second language in the Océ Express WebTools. See ‘Change
the regional settings’ on page 84. The Océ PlotWave 900 supports a total of 20 languages.
How to select a language
1.
Open the ‘Preference’ card in the ‘Original’ section.
2.
Press the “Language” function key to set the needed language.
3.
Press the ‘Preference’ section key again to activate the selection.
Chapter 5 - Use the Océ PlotWave 900 scanner to copy154
Change the operator panel language
To Next Page
Loading...
