Select a language
Introduction
On the operator panel of the Océ PlotWave 900 printer, you can specify which language
you want to use to display printer information, such as status and error messages. By de-
fault, you can choose between two languages that are defined in the Océ Express WebTools
for your system by the key operator (see ‘Change the regional settings’ on page 84). The
Océ PlotWave 900 supports a total of 20 languages.
Select a language
1.
Press the ‘Online’ key on the printer operator panel to put the printer offline. The message
‘Offline’ is displayed in the status window.
2.
Press the left selection key to shift the focus to the Language option. A shadow effect is
used to indicate that the focus is set to this option.
3.
Activate the Language option by pressing the right selection key. The dotted line around
the current selection changes into a solid line and the small selection triangles next to the
specified language are no longer dimmed.
4.
Use the arrow keys to switch between the two predefined languages.
5.
The language-specific elements on the display are immediately customized to reflect your
language choice. Only the indicator for the language itself is in the alternative language.
This way you always know what your alternative language is.
6.
Put the printer online again by pressing the “Online” key. The printer now uses the se-
lected language.
Chapter 2 - Get to know the Océ PlotWave 900 system36
Select a language