Oce PlotWave 900 - Reinforcement Unit Maintenance

Introduction to reinforcement unit maintenance
Note:
To avoid damage to the reinforcement unit, use only the original reinforcement strips
from Océ.
Maintenance of the reinforcement unit
This section covers maintenance activities for the optional reinforcement unit of the
folder.
The following actions will be described.
•
Insert a new tape roll. See ‘Insert a new tape roll’ on page 278.
•
Empty the waste box. See ‘Empty the waste box’ on page 286.
•
Clean the reinforcement knives. See ‘Clean the reinforcement knives’ on page 288.
Chapter 11 - System maintenance 277
Introduction to reinforcement unit maintenance