Oce PlotWave 900 User Manual

1.
Select one of the roll selection keys on the operator panel.
2.
Select the 100% key.
3.
Make sure that ‘auto zoom’, ‘auto roll’, and ‘scan width’ are not selected.
4.
Make other settings as required.
5.
Feed the original.
Leading and trailing strip
1.
It is possible to adjust the length of both the leading and trailing strips to eliminate or
add a filing strip. Leading and trailing strips can be extended up to 400 mm or shortened
up to 400 mm (15.7 inches).
Copy with removed filing strips along the leading and trailing strip
1.
Open the “Sheet” card in the “Original” section.
2.
Press the “Remove strip” function key.
[141] Remove strip
3.
Adjust the values for the trailing strip using the numeric or arrow keys.
4.
Press the “Remove strip” function key again.
5.
Adjust the values for the leading strip using the numeric or arrow keys.
6.
Make other settings as required.
7.
Feed the original.
Chapter 8 - Special copy and scan jobs216
Scanning originals with filing strip

Oce PlotWave 900 Specifications