7.
Clean the upper and lower knife using Cleaner K.
[208] Cleaning the upper and lower knife
8.
Use the Fixing Unit Cleaning Oil (silicon oil) to oil the felt.
[209] Oiling the felt
9.
Close the side door of the reinforcement unit. The knives are automatically put back in
their home positions. The picture on the display disappears and the message “Press start
to resume job” or “Ready to print” appears, depending on whether or not a job was inter-
rupted to clean the knives.
10.
Press the Online key.
Chapter 11 - System maintenance 289
Clean the reinforcement knives
To Next Page
Loading...
