Oce PlotWave 900 User Manual

Correction key
Use the Correction key to do the following:
1.
Press the Correction key one time to return to the default value of the active setting and
to set the numeric display to 1.
2.
Press the Correction key two times to return to the start screen of the scanner operator
panel. When job templates are enabled in the Océ Express WebTools, the top layer shows
the job templates. When job templates are not enabled in the Océ Express WebTools,
the top layer shows the ‘Custom’ section.
When ‘Automatic feed’ is selected for a single sheet job, this setting stays active.
Job interrupt only stays active for one job. You have to press the Job interrupt key before
each new job you want to give interrupt priority.
The scanner operator panel will automatically return to the top layer and the default
settings after the time defined in the ‘Panel Timeout’ setting in the Océ Express WebTools.
Chapter 5 - Use the Océ PlotWave 900 scanner to copy156
Settings on the Océ PlotWave 900 scanner operator panel

Oce PlotWave 900 Specifications