Oce PlotWave 900 User Manual

Note:
If you select 'Middle', make sure the original width is properly specified as described in
the section about ‘The scan width’ on page 227:
•
'Standard' if a standard sized original is used
•
The exact original width (numeric) if a non-standard sized original is used.
3.
Feed your original.
Note:
With ‘Synchro cut’ the system cuts at the measured length of the original times the zoom
factor. The minimum length is 279 mm or 11 inches. No information loss occurs when
'Synchro cut' is used.
[160] Auto shift options with synchro cut option active
In ‘Shift the image’ on page 237, you can read how to define the exact location of your
image on the page.
Chapter 8 - Special copy and scan jobs236
Auto align

Oce PlotWave 900 Specifications