Configuring Multi-chassis Link Aggregation Quick Steps for Configuring MCLAG
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 10-7
9 Verify the consistency of system-level mandatory parameters between the two chassis using the show
multi-chassis consistency command as shown below:
OS10K [Chassis 1] -> show multi-chassis consistency
Consistency Local Peer Status
-------------------------------+----------------+----------------+-------------
Chassis-ID 1 2 OK
Chassis-Type OS10K OS10K OK
Hello-Interval 1 1 OK
IPC-VLAN 4094 4094 OK
Chassis-Group 10 10 OK
STP-Path-Cost-Mode Auto Auto OK
STP-Mode Per-VLAN Per-VLAN OK
OS10K [Chassis 2] -> show multi-chassis consistency
Consistency Local Peer Status
-------------------------------+----------------+----------------+-------------
Chassis-ID 2 1 OK
Chassis-Type OS10K OS10K OK
Hello-Interval 1 1 OK
IPC-VLAN 4094 4094 OK
Chassis-Group 10 10 OK
STP-Path-Cost-Mode Auto Auto OK
STP-Mode Per-VLAN Per-VLAN OK
10 Save the configuration and reload using the write memory and reload commands as shown below:
-> write memory
-> reload from working no rollback-timeout
11 Once the system reboots verify the multi-chassis functionality using the commands shown below:
OS10K [Chassis 1] -> show multi-chassis vf-link member-port
VFLink ID Slot/Port Oper Is Primary
---------------+--------------+--------------+------------
0 1/1 Up Yes
0 1/17 Up No
0 3/1 Up No
0 3/17 Up No
OS10K [Chassis 2] -> show multi-chassis vf-link member-port
VFLink ID Slot/Port Oper Is Primary
---------------+--------------+--------------+------------
0 2/1 Up No
0 2/17 Up Yes
0 4/1 Up No
0 4/17 Up No
OS10K [Chassis 1] -> show multi-chassis status
Multi-Chassis Operational Configured
---------------------+---------------------+-------------------
Chassis ID 1 1
Chassis Role Primary N/A
Status Up N/A
Hello Interval 1s 1s
IPC VLAN 4904 4094