EasyManuals Logo

OmniSwitch os6900 User Manual

Default Icon
942 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #460 background imageLoading...
Page #460 background image
Configuring Redistribution Configuring RIP
page 19-16 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Configuring Route Map Redistribution
The ip redist command is used to configure the redistribution of routes from a source protocol into the
RIP destination protocol. This command is used on the RIP router that performs the redistribution.
A source protocol is a protocol from which the routes are learned. A destination protocol is the one into
which the routes are redistributed. Make sure that both protocols are loaded and enabled before configur-
ing redistribution.
Redistribution applies criteria specified in a route map to routes received from the source protocol. There-
fore, configuring redistribution requires an existing route map. For example, the following command
configures the redistribution of OSPF routes into the RIP network using the ospf-to-rip route map:
-> ip redist ospf into rip route-map ospf-to-rip
RIP routes received by the router interface are processed based on the contents of the ospf-to-rip route
map. Routes that match criteria specified in this route map are either allowed or denied redistribution into
the RIP network. The route map can also specify the modification of route information before the route is
redistributed. See “Using Route Maps” on page 19-12 for more information.
To remove a route map redistribution configuration, use the no form of the ip redist command. For exam-
ple:
-> no ipv6 redist ospf into rip route-map ospf-to-rip
Use the show ip redist command to verify the redistribution configuration:
-> show ip redist
Source Destination
Protocol Protocol Status Route Map
------------+------------+---------+--------------------
LOCAL4 RIP Enabled rip_1
LOCAL4 OSPF Enabled ospf_2
LOCAL4 BGP Enabled bgp_3
RIP OSPF Enabled ospf-to-rip
Configuring the Administrative Status of the Route Map Redistribution
The administrative status of a route map redistribution configuration is enabled by default. To change the
administrative status, use the status parameter with the ip redist command. For example, the following
command disables the redistribution administrative status for the specified route map:
-> ip redist ospf into rip route-map ospf-to-rip admin-state disable
The following command example enables the administrative status:
-> ip redist ospf into rip route-map ospf-to-rip admin-state enable

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the OmniSwitch os6900 and is the answer not in the manual?

OmniSwitch os6900 Specifications

General IconGeneral
BrandOmniSwitch
Modelos6900
CategorySwitch
LanguageEnglish