Omron MX2 - Page 307

285
ModBus Data Listing Section B-4
Note 1 Assume that the rated current of the inverter is "1000".
Note 2 If a number not less than "1000" (100.0 seconds) is specified, the second
value after the decimal point will be ignored.
Note 3 0902h setting is referred for one time when following 06H command is exe-
cuted
004Eh Programming error monitoring d090 R Warning code –
004Fh to
006Ch
(reserved) – – – –
006Dh to
08Efh
(reserved) – – – –
0900h Writing to EEPROM – W 0: Motor constant recalculation
1: Save all data in EEPROM
Other: Motor constant recalculation and
save all data in EEPROM
–
0901h Unused – – Inaccessible –
0902h EEPROM write mode – W 0 (invalid) / 1 (valid)
0903h to
1000h
Unused – – Inaccessible –
Register
No.
Function name Function
code
R/W Monitoring and setting items Data
resolution