A10E/A28E/A28F Configuration Guide
Figure 4-6 SP scheduling
WRR: on basis of round schedule each queue according to queue priority, schedule
packets in various queues according to weight of each queue, as shown in below.
Figure 4-7 WRR scheduling
SP+WRR: dividing queues on interface into two groups, you can assign some queues
perform SP schedule and other queues perform WRR schedule.
4.1.7 Rate limiting based on interface and VLAN
The A10E/A28E not only supports rate limiting based on traffic policy but also supports rate
limiting based on interface or VLAN ID. Similar to rate limiting based on traffic policy, the
A10E/A28E discards the exceeding traffic.