Orion A10E - Configuring Basic Functions of Pppoe; Default Configurations of Pppoe

Orion Networks
A10E/A28E/A28F Configuration Guide
6 Security
Orion Networks
192
6.9.3 Default configurations of PPPoE+
The default configuration of I PPPoE+ is as below.
Function
Default value
Global PPPoE
Disable
Interface PPPoE
Disable
Padding mode of Circuit ID
Switch
Circuit ID information
Interface ID/VLAN ID/attached string
Attached string of Circuit ID
hostname
Padded MAC address of Remote ID
MAC address of the switch
Padding mode of Remote ID
Binary
Interface trusted status
Untrusted
Tag overriding
Disable
By default, PPPoE packet is forwarded without being attached any information.
6.9.4 Configuring basic functions of PPPoE+
PPPoE+ is used to process PADI and PADR packets. It is designed for the PPPoE
client. In general, PPPoE+ is only enabled on interfaces that are connected to the
PPPoE client. Trusted interfaces are interfaces through which the switch is connected
to the PPPoE server. PPPoE+ and trusted interface are exclusive. An interface is
either enabled with PPPoE+ or is a trusted interface.
Enabling PPPoE+
After interface PPPoE+ is enabled, PPPoE authentication packets sent to the interface will be
attached with user information and then are forwarded to the trusted interface.
Enable PPPoE+ for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#interface port
port-id
Enter physical layer interface configuration
mode.
3
Alpha-A28E(config-
port)#pppoeagent enable
Enable interface PPPoE+.
Note