Orion A10E - Example for Configuring the MAC Address Table; Figure 2-1 MAC Application Networking; Maintenance

Orion Networks
A10E/A28E/A28F Configuration Guide
2 Ethernet
Orion Networks
39
2.1.10 Maintenance
Maintain the A10E/A28E as below.
Command
Description
Alpha-A28E(config)#clear mac-address-table { all
| blackhole | dynamic | static } [ vlan vlan-
id ]
Clear MAC address.
Alpha-A28E#search mac-address mac-address
Search MAC address.
2.1.11 Example for configuring the MAC address table
Networking requirements
Configure static unicast MAC address for Port 2 on Switch A, and configure the aging time
for dynamic MAC addresses (it takes effect only after dynamic MAC address learning is
enabled).
As shown in Figure 2-1, configure Switch A as below:

Create VLAN 10 and activate it.

Configure a static unicast MAC address 0001.0203.0105 on Port 2 and set its VLAN to
VLAN 10.

Set the aging time to 500s.
Figure 2-1 MAC application networking
Configuration steps
Step 1 Create VLAN 10 and active it, and add Port 2 into VLAN 10.