A10E/A28E/A28F Configuration Guide
Set the attached string of the Circuit ID to alpha-a28e. Set the padding content of the
Circuit ID on Port 1 to user01. Set the padding content of the Remote ID on Port 2 to the
MAC address of the client. The padding contents are in ASCII mode.
Enable Tag overriding on Port 1 and Port 2.
Figure 6-12 Configuring PPPoE+
Configuration steps
Step 1 Set Port 3 to the trusted interface.
Alpha-A28E#config
Alpha-A28E(config)#interface port 3
Alpha-A28E(config-port)#pppoenagent trust
Alpha-A28E(config-port)#exit
Step 2 Configure packet information of Port 1 and Port 2.
Alpha-A28E(config)#pppoeagent circuit-id attach-string alpha-a28e
Alpha-A28E(config)#interface port 1
Alpha-A28E(config-port)#pppoeagent circuit-id user01
Alpha-A28E(config-port)#exit
Alpha-A28E(config-port)#interface port 2
Alpha-A28E(config-port)#pppoeagent remote-id client-mac
Alpha-A28E(config-port)#pppoeagent remote-id format ascii
Alpha-A28E(config-port)#exit
Step 3 Enable Tag overriding on Port 1 and Port 2.
Alpha-A28E(config)#interface port 1
Alpha-A28E(config-port)#pppoeagent vendor-specific-tag overwrite enable
Alpha-A28E(config-port)#exit
Alpha-A28E(config)#interface port 2
Alpha-A28E(config-port)#pppoeagent vendor-specific-tag overwrite enable
Alpha-A28E(config-port)#exit
To Next Page
Loading...